202 Vehicle care
14. When the correct pressure
is obtained, switch off the
compressor.
Warning
Do not over inate tyres due
to risk of injury or damage to
the tyre.
15. If the tyre pressure is not
obtained within 10 minutes,
remove the tyre repair kit.
16. Move the vehicle one tyre
rotation.
17. Reattach the tyre repair kit and
continue the lling procedure for
10 minutes.
Warning
If the recommended pressure
cannot be reached after
approximately 10 minutes, the
vehicle should not be driven. The
tyre is too severely damaged and
the tyre repair kit cannot inate
the tyre. Disconnect and stow the
tyre repair kit back in its original
position. Contact a Holden
Dealer.
18. Drain excess tyre pressure with
the button over the pressure
indicator.
Do not run the compressor
longer than 10 minutes.
19. Detach the tyre repair kit.
20. Push the catch on the bracket to
remove the sealant bottle from
the bracket.
21. Screw the tyre ination hose to
free the connection of the sealant
bottle. This prevents sealant from
escaping.
22. Stow the tyre repair kit in the
load compartment.
Warning
Always stow the tyre repair kit in
its original position. Unsecured
loads increase the risk of injury
during heavy braking, sudden
avoidance manoeuvres or a
collision.
23. Remove any excess sealant
using a cloth.
24. After inating the tyre, remove
the maximum speed label and
place it in a visible location.
It reminds you to drive cautiously
and not to exceed 80 km/h until
the damaged tyre is replaced or
repaired.
To Next Page
Loading...
