Hologic DISCOVERY A - Tightening the Transformer Seal Screws; Tightening the Tank Cover Gasket Screws

Discovery QDR Series Technical Manual
6-14
Figure 6-4. Bladder Gasket Screws
6.15.5 Tightening the Transformer Seal Screws
Tighten the Transformer Seal screws using the torque settings in the table above and the
sequence in the figure below.
Figure 6-5. Transformer Screws
6.15.6 Tightening the Tank Cover Gasket Screws
Refer to the figure below and the torque settings in the table above and tighten the Tank
Cover Gasket screws as follows:
1. Tighten screws #1 through #6 in the sequence as indicated.
2. Starting at the screw next to screw #6, move in a clockwise direction and tighten
alternate screws.
3. Repeat this pattern in a clockwise direction and tighten all remaining screws.
1
4
2
3
4
2
1
3