Holzmann K5 260L - Page 4

INHALT /INDEX
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 4
5-fach Kombination / combined 5-operation machine K5 260L
13 ASSEMBLY 42
13.1 Scope of delivery 42
13.1.1 Workplace ...................................................................................................42
13.1.2 Transport / unloading the machine .................................................................42
13.1.3 Preparation of the surface .............................................................................43
13.2 Assembly 44
13.2.1 Mount planing shafts cover ............................................................................44
13.2.2 Assembly / disassembly of the saw blade ........................................................44
13.2.3 Mortiser mount (optional) .............................................................................44
13.2.4 Mounting the spindle shaper protection ...........................................................45
Power supply 45
13.2.5 Control .......................................................................................................46
13.3 Prior to the commissioning 46
13.3.1 Setting the riving knife .................................................................................46
14 OPERATION 46
14.1 Notes on Operation 46
14.2 operation 47
14.2.1 Machine switch ON – OFF ..............................................................................47
14.3 Saw 47
14.3.1 Saw blade height adjustment ........................................................................48
14.3.2 Adjustment of the saw blade tilt .....................................................................48
14.3.3 Notes on using the circular saw......................................................................48
14.4 Planer 48
14.4.1 Information for Planer ..................................................................................49
14.4.2 Planing or narrow workpieces ........................................................................49
14.4.3 Planing with a tilted angle stop ......................................................................49
14.4.4 Planing short workpieces ...............................................................................50
14.4.5 Planing of workpieces with a small cross-section ..............................................50
14.5 Thicknesser 50
14.5.1 Conversion work for thicknessing .............................................................50
14.6 Milling 52
14.6.1 Changing the milling head .............................................................................52
14.6.2 Setting of the milling spindle height ...............................................................52
14.7 Working with the mortiser (optional) 53
15 MAINTENANCE 54
15.1 Monthly maintenance 54
15.1.1 Change diameter of the cutter shaft ...............................................................55
15.1.2 Saw blade change see 13.2.2 ........................................................................55
15.2 Cleaning 56