4 - 9
LED Illumination - Presentation Mode
If you wish to set the illumination LED brightness, scan one of the bar
codes below. This sets the LED illumination for the scanner when it is in
Presentation Mode. (If the scanner is triggered manually, the LED illumina-
tion will switch to the setting for a manual trigger. See LED Illumination -
Manual Trigger on page 4-7.)
Default = High.
Note: The LEDs are like a flash on a camera. The lower the ambient light
in the room, the brighter the LEDs need to be so the scanner can
“see” the bar codes.
Note: LED Illumination - Presentation Mode does not apply to Streaming
Presentation™ Mode or Mobile Phone Read Mode.
Presentation LED Behavior after Decode
When a scanner is in presentation mode, the LEDs dim 30 seconds after a
bar code is decoded. If you wish to dim the LEDs immediately after a bar
code is decoded, scan the LEDs Off bar code, below.
Default = LEDs On.
To Next Page
Loading...
