3 - 32
Bluetooth HID Keyboard Disconnect
If your scanner has been connected directly to an iPad, smart phone, or
laptop using Bluetooth HID Keyboard Connect (page 3-29), you must dis-
connect it in order to once again communicate with the base or Access
Point. Scan the Bluetooth HID Keyboard Disconnect bar code to unlink
the scanner from the currently linked host. Scan the linking bar code on
the base or Access Point to relink the scanner.
Bluetooth Serial Port - PCs/Laptops
Scanning the Non-Base BT Connection bar code below allows the scan-
ner to be used with other Bluetooth devices (e.g., PC/laptop). When in this
mode, the scanner behaves like an RS-232 serial device, and you will need
to open a COM port on the host to read scanned data.
After you scan the bar code below, follow the instructions supplied with
your Bluetooth device to locate the scanner and connect to it. If you go out
of range with your scanner, the scanner will not reconnect to the Bluetooth
device when it is back in range. If you want to relink to the charge base or
Access Point, refer to Override Locked Scanner, page 3-14.
Note: The multiple work groups option is not available when you are using
the scanner with Bluetooth devices other than the charge base or
Access Point.
PDAs/Mobility Systems Devices
You may also use the scanner with a PDA or a Honeywell Mobility Systems
device. Scan the bar code below and follow the instructions supplied with
your Bluetooth device to locate the scanner, and connect with it.
Bluetooth HID Keyboard Disconnect
BT Connection - PDA/Mobility Systems Device
To Next Page
Loading...
