Honeywell 4850DR - Page 134

9 - 15
EAN/JAN-8 Addenda *2 Digit Addenda Off EA8AD20 6-28
2 Digit Addenda On EA8AD21 6-28
*5 Digit Addenda Off EA8AD50 6-28
5 Digit Addenda On EA8AD51 6-28
EAN/JAN-8 Addenda Required *Not Required EA8ARQ0 6-29
Required EA8ARQ1 6-29
Addenda Timeout Range (0 - 65535) *100 DLYADD##### 6-29
EAN/JAN-8 Addenda
Separator
Off EA8ADS0 6-29
*On EA8ADS1 6-29
MSI Default All MSI Settings MSIDFT 6-30
*Off MSIENA0 6-30
On MSIENA1 6-30
MSI Check Character *Validate Type 10, but Don’t
Transmit
MSICHK0 6-30
Validate Type 10 and
Transmit
MSICHK1 6-30
Validate 2 Type 10 Chars, but Don’t
Transmit
MSICHK2 6-30
Validate 2 Type 10 Chars and
Transmit
MSICHK3 6-30
Validate Type 10 then Type 11
Char, but Don’t Transmit
MSICHK4 6-30
Validate Type 10 then Type 11
Char and Transmit
MSICHK5 6-31
Disable MSI Check Characters MSICHK6 6-31
MSI Message Length Minimum (4 - 48) *4 MSIMIN## 6-31
Maximum (4 - 48) *48 MSIMAX## 6-31
GS1 DataBar Omnidirectional Default All
GS1 DataBar Omnidirectional
Settings
RSSDFT 6-32
Off RSSENA0 6-32
*On RSSENA1 6-32
GS1 DataBar Limited Default All GS1 DataBar Limited
Settings
RSLDFT 6-32
Off RSLENA0 6-32
*On RSLENA1 6-32
GS1 DataBar Expanded Default All GS1 DataBar
Expanded Settings
RSEDFT 6-33
Off RSEENA0 6-33
*On RSEENA1 6-33
GS1 DataBar Expanded Msg.
Length
Minimum (4 - 74) *4 RSEMIN## 6-33
Maximum (4 - 74) *74 RSEMAX## 6-33
Trioptic Code *Off TRIENA0 6-33
On TRIENA1 6-33
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric entry
Page