3 - 8
CodeGate
®
When CodeGate is On, the trigger is used to allow decoded data to be transmitted to the host system. The scanner remains on,
scanning and decoding bar codes, but the bar code data is not transmitted until the trigger is pressed. When CodeGate is Off,
bar code data is transmitted when it is decoded. Default = CodeGate Off Out-of-Stand.
Hands Free Time-Out
Presentation Modes are referred to as “hands free” modes. If the scanner’s trigger is pressed when using a hands free mode,
the scanner changes to manual trigger mode. You can set the time the scanner should remain in manual trigger mode by set-
ting the Hands Free Time-Out. Once the time-out value is reached, (if there have been no further trigger presses) the scanner
reverts to the original hands free mode.
Scan the Hands Free Time-Out bar code, then scan the time-out duration (from 0-300,000 milliseconds) from the inside back
cover, and Save. Default = 5,000 ms.
Reread Delay
This sets the time period before the scanner can read the same bar code a second time. Setting a reread delay protects against
accidental rereads of the same bar code. Longer delays are effective in minimizing accidental rereads. Use shorter delays in
applications where repetitive bar code scanning is required. Reread Delay only works when in a Scan Stand Presentation
Mode (see page 3-6). Default = Long.
Left of
Presentation Centering
Window
Right of Presentation Centering
Window
* CodeGate Off
Out-of-Stand
To Next Page
Loading...
Need help?
General