To Next Page

To Previous Page

6 - 16

Code 128 Append

This function allows the scanner to append the data from several Code 128 bar codes together before transmitting them to

the host computer. When the scanner encounters a Code 128 bar code with the append trigger character(s), it buffers

Code 128 bar codes until it reads a Code 128 bar code that does not have the append trigger. The data is then transmitted

in the order in which the bar codes were read (FIFO). Default = On.

Code 128 Code Page

Code pages define the mapping of character codes to characters. If the data received does not display with the proper

characters, it may be because the bar code being scanned was created using a code page that is different from the one the

host program is expecting. If this is the case, scan the bar code below, select the code page with which the bar codes were

created (see ISO 2022/ISO 646 Character Replacements on page A-8), and scan the value and the Save bar code from

the Programming Chart on the inside the back cover of this manual. The data characters should then appear properly.

* On

Off

Code 128 Code Page

Honeywell 4850DR Guide

Other manuals for Honeywell 4850DR