Honeywell 4850DR - GS1 Databar Expanded; Trioptic Code

6 - 33
GS1 DataBar Expanded
< Default All GS1 DataBar Expanded Settings >
GS1 DataBar Expanded On/Off
GS1 DataBar Expanded Message Length
Scan the bar codes below to change the message length. Refer to Message Length Description (page 6-1) for additional
information. Minimum and Maximum lengths = 4-74. Minimum Default = 4, Maximum Default = 74.
Trioptic Code
Note: If you are going to scan Code 32 Pharmaceutical codes (page 6-5), Trioptic Code must be off.
Trioptic Code is used for labeling magnetic storage media.
* On
Off
Minimum Message Length
Maximum Message Length
On
* Off