Setup (Cont'd)
47
User Setup
Each user must be assigned a name with a corresponding 4-digit user
code in order to gain access to various features and functions. The
TouchCenter can hold the identity for 10 Users in its memory. If
additional Users are needed, define the additional Users using the
Console Emulation Mode.
Users for the system are programmed in a central user setup location
that provides the specific questions for authorization levels assigned
to different users. You may want these users to be the same, but
there are situations in which you may want a user to have limited
capabilities. These capabilities are defined by the Authority Level
assigned each user.
Authority Levels
Authority levels define the system functions a particular user can
perform. Depending on the authority assigned to you, there are
certain system functions you may be prohibited from performing. The
following information describes the authority levels that can be
assigned through the TouchCenter and provides the equivalent
authority level name that you will find if you are reading your alarm
system manuals. The authority levels that can be assigned through
the TouchCenter are as follows:
Equivalent System Name Touch-
Center
Authority
Level
Functions
Residential
Systems
Commercial
Systems
Master Can perform all security functions,
add/delete users in assigned
partition, program scheduled events,
and change partition master code
Partition
Master
Level 1
Master
Normal Perform security functions (arm,
disarm)
Standard
User
Level 3
Operator A
Guest Can arm the system in assigned
partitions, but cannot disarm the
system unless the system was armed
with this code.
Note: Do not assign this level if
Quick Arm is enabled in your system.
Guest Level 4
Operator B
No
Access
Used to restrict access from a
partition.
N/A N/A
To Next Page
Loading...
