Honeywell Accenta - Page 36

Accenta/Optima Engineer’s Manual
32
LED Keypad:
Press to toggle double knock status on or off.
Press [9] to turn all double knock zones on.
Press [0] to turn all double knock zones off.
• Press to enter into menu. LED’s 1 and 2 are on.
• Press [1] to select Double Knock.
• Press zone number [1-8] to choose a particular zone.
• Press the zone [number] or to toggle the double knock
status on or off. The appropriate LED is on when the zone is
set up as Double Knock. Default settings are off.
• Press twice to leave the menu.
2 = Omit Allow
When a zone is programmed as Omit Allow, the panel allows the zone to be omitted for one set period by the
user when setting the system.
Programming a Zone as Omit Allow
The [up arrow] scrolls through zones.
Press to toggle omit allow status on or off.
Press [9] to turn all omit allow zones on.
Press [0] to turn all omit allow zones off.
LCD Keypad:
While in Engineer program mode press or press until
0>Omit allow & Double Knock is displayed then press .
• Press [2] to select Omit Allow. The first zone is
displayed with status on or off.
• Press the [zone number] or to toggle the
status on or off.
• Press the or [zone number] to go to the
other zones and follow the same procedure as above.
• Press twice to leave the menu.
Omit Allow & Double Knock
[1]
12
3
4
5
6
7
8
[1-8] or
12
3
4
5
6
7
8
12
3
4
5
6
7
8
12
3
4
5
6
7
8
1. Double Knock
2. Omit Allow
[2]
Omit Allow &
Double Knock
2: <Zone Name>
Omit Allow:NO
2: <Zone Name>
Omit Allow:YES
[zone number] or