Honeywell BC-200 - Isolate Analog Devices and Ranges

Panel Operation
BC-200 Manual – P/N DOC-01-013 54
7.3.4.6 SERVICE MENU – ISOLATE – ANALOG LIST
This screen allows the operator to isolate or de-isolate an Analog addressable point.
First you are prompted to select the required Analog addressable loop:
1) LOOP 1
2) LOOP 2
3) LOOP 3
4) LOOP 4
5) LOOP 5
6) LOOP 6
7) LOOP 7
8) LOOP 8
9) LOOP 9
10) LOOP 10
ISOLATE ANALOG LOOP LIST
01 OCT 1999 14:44:37
A = 0
F = 0
I = 0
N = 0
SELECT
20 JULY 2002 14:44:37
USE BUTTONS/NUMBERS TO SELECT LOOP
DAY MODE
BACKUP DOWN
Actions:
 Use the UP and DOWN buttons to scroll through
the Analog loop list.
 Use the SELECT button to select the loop to list.
 Alternatively press 1 through 4 .
Once you have selected the loop you will be prompted to select Analog addressable detectors or modules as
follows:
SELECT DEVICE ON LOOP 1:
1) DETECTOR
2) MODULE
ISOLATE – DETECTOR/MODULE
20 JULY 2002 14:44:37
A = 0
F = 0
I = 0
N = 0
SELECT
USE BUTTONS/NUMBERS TO SELECT DEVICE
DAY MODE
BACKUP DOWN
Actions:
 Use the UP and DOWN buttons to select option.
 Use the SELECT button to select the loop to list.