Honeywell Chadwick-Helmuth 8500C+ User Manual

Maintenance
8500C/8500C+ System Maintenance Manual A-19
cy. Move magnetic pickup cable P/N 10808 to channel D and Velo cable P/N 11210 to
channel 4 on 8520C-36. Repeat steps cq through cv, but substitute the following values:
PICKUP: CHANNEL <D>
INPUT: CHANNEL 4
A.4.4.4 8500C/C+/8520C-36 Spectrum Test (P-3 Setup)
NOTE: The same test setup and 8500C/C+ settings are to be left as they were in Section
A.4.4.3, “Test Procedure (P-3 Setup).”
Perform test procedure in Section 5.4.1.4, “Spectrum Test.”
A.4.4.5 8500C/C+/8520C-36 Track Test (P-3 Setup)
NOTE: The same test setup and 8500C/C+ settings are to be left as they were in Section
A.4.4.3, “Test Procedure (P-3 Setup).”
Perform test procedure in Section 5.4.1.5, “Track Test.”
A.4.5 8500C/C+/8520C-36 Spectrum Accuracy Test
a. Set up equipment as shown in Figure A-7.
b. Perform test procedure in Section 5.5.3, “Spectrum Accuracy Test.”

Honeywell Chadwick-Helmuth 8500C+ Specifications

General

Brand	Honeywell
Model	Chadwick-Helmuth 8500C+
Category	Measuring Instruments
Language	English