EasyManuals Logo

Honeywell Enraf SmartRadar FlexLine User Manual

Honeywell Enraf SmartRadar FlexLine
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
Installation SmartRadar FlexLine
Installation Guide Part No.: 4417.760_Rev06
26
4.9 Installing the Cable Glands and Stopping Plugs with
SmartConn
4.9.1 Cable Glands
Use increased safe (Ex-e) M20 cable glands with an appro-
priate IP value.
See the type plate on the device.
4.9.2 Unused Cable Inlets
Seal unused cable inlets with approved threaded stopping
plugs.
4.10 Installing the Compound Glands, Conduits, and Stopping
Plugs without SmartConn
Depending on local regulations, this device can be cabled by
using compound glands, direct entry, or conduits.
CAUTION!
Only use Ex-e or flameproof certified materials of an
appropriate IP value.
CAUTION!
Improper installation of cable glands or stopping plugs
will invalidate the Ex approval of the SmartRadar.
NOTE:
Install the cable glands according to the instructions
provided by the manufacturer.
CAUTION!
Only use Ex-d certified materials of an appropriate IP
value.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell Enraf SmartRadar FlexLine and is the answer not in the manual?

Honeywell Enraf SmartRadar FlexLine Specifications

General IconGeneral
BrandHoneywell
ModelEnraf SmartRadar FlexLine
CategoryRadar
LanguageEnglish

Related product manuals