Need help?Do you have a question about the Honeywell Envitec MySignO and is the answer not in the manual?
General| Sensor technology | Electrochemical |
|---|---|
| Response time | <15 seconds |
| Operating temperature | -20°C to +50°C |
| Power supply | 2 x AA alkaline batteries |
| Battery life | Approximately 1 year |
| Dimensions | 145 x 80 x 38 mm |
| Display | LCD |
| Resolution | 0.1 % O2 |
| Storage temperature | -20°C to +50°C |
| Humidity | 10 – 95 % RH, non-condensing |
| Operating Humidity | 10 - 95% RH, non-condensing |
| Weight | 250 g |
Describes the device's intended use and required user qualifications.
Procedure for installing the oxygen sensor and connecting the device.
Instructions for charging the battery via external power or USB port.
Diagram showing the main menu structure and navigation paths.
Step-by-step guide for powering the unit on and off.
Setting up alarms for excessive and insufficient oxygen concentrations.
Configures highest and lowest oxygen levels that trigger an alarm.
Steps for calibrating the system using ambient air or pure oxygen.
Troubleshooting common errors during calibration and value recording.
Step-by-step guide for replacing the rechargeable battery.
Steps to remove, return, connect, and calibrate a new oxygen sensor.
To Next Page