Oxygen measuring device MySign
®
O
Doc no.: 065-07-1001825_MySignO_GB-0.pdf / 12.11 15
4.4 Switching the unit on / off
Once the unit has been switched on, it will automatically test all of its internal functions and
components. While performing these tests, the unit will display its software version, hardware
version and serial number for around 2 seconds on the screen.
Switching on the unit
Hold the button pressed for around 1 second
The unit will be ready to take measurements after approx. 5 seconds.
Example: Information displayed while the unit is being switched on:
If the measurement data have been
personalised using the computer's
software, the screen will display a prompt
asking whether this data is to be copied
over after the unit has been switched on.
If this prompt regarding copying the personalised measurement data is not
confirmed within 2 minutes, they are not copied. In that case, the system will
generate a new measurement series record.
To Next Page
Loading...
Need help?
General
