Oxygen measuring device MySign
®
O
Doc no.: 065-07-1001825_MySignO_GB-0.pdf / 12.11 23
4.7.2 Measurement series
A measurement series comprises all of the oxygen concentration measurements that are
taken during one measuring cycle. A new measuring cycle is started every time the unit is
switched off and on, and each new series of measurements is assigned a separate ID.
Measurements are always taken at intervals of one second. The data the system stores in the
memory is the average oxygen concentration measured per minute.
Select “Measurement series” from the “Data
memory” menu.
Low level priority warning
(e.g. low battery charge)
Medium level priority warning
(e.g. upper alarm limit has been exceeded)
High level priority warning
(e.g. oxygen concentration is less than 18%)
Flagged
For additional information on the priority levels, see section “Alarm messages”.
To Next Page
Loading...
Need help?
General
