Galaxy 3 Series Programming Manual
D-2
Event Log (cont’d)
NOTE: M = Mandatory. NM = Non-Mandatory
NOTE: A plus (+) means an event has started. A negative (-) means an event has finished.
KEYPAD TEXT DESCRIPTION Trigger Event
DURESS Duress code has been entered. 1. PA/Duress M
ENG ASSEM Engineering Assemble Zone menu (Menu Option 64) has been accessed. 14. Menu Access M
ENG CHECK Engineering Pre-Check menu (Menu Option 66) has been accessed. 14. Menu Access M
ENG DIAG Engineering Diagnostics menu (Menu Option 61) has been accessed. 14. Menu Access M
ENG DIGI Engineering Digicom (Communications) (Menu Option 56) has been accessed. 14. Menu Access M
ENG GROUP Engineering Groups (Menu Option 63) has been accessed. 14. Menu Access M
ENG KPAD Engineering Keypad (Menu Option 58) has been accessed. 14. Menu Access M
ENG LINKS Engineering Links (Menu Option 54) has been accessed. 14. Menu Access M
ENG O/PS Engineering Outputs (Menu Option 53) has been accessed. 14. Menu Access M
ENG PARAM Engineering Parameters (Menu Option 51) has been accessed. 14. Menu Access M
ENG PRINT Engineering Print (Menu Option 57) has been accessed. 14. Menu Access M
ENG QUICK Engineering Quick Menu (Menu Option 59) has been accessed. 14. Menu Access M
ENG SOAK Engineering Soak Test (Menu Option 55) has been accessed 14. Menu Access M
ENG TEST Engineer Test of the system via the Telecom Module. Always TR NM
ENG TMRS Engineering Timers A/B (Menu Option 65) has been accessed. 14. Menu Access M
ENG ZONES Engineering Zones (Menu Option 52) has been accessed. 14. Menu Access M
ENG TAMP Tamper when entering Engineer Mode. None NM
ENGINEER + Entering Engineer mode. Always TR NM
ENGINEER – Leaving Engineer mode. Always TR NM
ENT DELAY User entering Ent Delay State None NM
ENT SET User entering Ent Set State None NM
ENT SETNG User entering Setting State None NM
ENT UNSET User entering Unset State None NM
ENT UNSTG User entering Unsetting State None NM
+ ENTRY Entry zone activated (opened) during Setting/Unsetting procedure or when Set. None NM
– ENTRY Entry zone de-activated (closed) during Setting/Unsetting procedure or when Set. None NM
ETST FAIL Engineer test has failed None NM
ETST PASS Engineer test has passed None NM
+ EXIT Exit zone activated (opened) during the Unsetting procedure or when Set. 2. Intruder NM
– EXIT Exit zone de-activated (closed) during the Unsetting procedure or when Set. 2. Intruder NM
EXITGUARD ExitGuard zone activated (opened). 16. Log NM
EXTENSION System or Group(s) are in the Autoset Extension period. 10. Setting NM
FAIL SET Fail to set event. 7. Set Fault M
FAULT RST Fault has been cleared 20. Fault NM
FB BATLOW RF Fob has low battery None NM
To Next Page
Loading...
Need help?
General
