Communications [56] Galaxy Flex Installer Manual
152
Remote Service [56.4]
1 = Access Period
1 = Off
2 = All Unset
3 = Any Set
4 = Any Time
2 = Direct Access
1 = PSTN (0 = Disabled, 1 = Enabled)
2 = GSM (0 = Disabled, 1 = Enabled)
3 = GPRS (0 = Disabled, 1 = Enabled)
4 = Ethernet (0 = Disabled, 1 = Enabled)
5 = USB (0 = Disabled, 1 = Enabled)
3 = Call back
1 = Call Back 1
0 = PSTN
1 = GSM
2 = GPRS
3 = Ethernet
2 = Call Back 2
3 = Call Back 3 Each one of these menu options
has the same sub-menus options
4 = Call Back 4 as 1 = Call Back 1
5 = Call Back 5
Remote Access Period [56.4.1]
U
se this option to control how the remote site is accessed by the Remote operator. There are
four modes:
1=Off Remote Servicing access to the panel is disabled.
2=All Unset Access only when all the groups are unset. If groups are not
enabled access is available at any time.
3=Any Set Remote Servicing access will only be granted if any of the groups
or the complete system are set.
4=Any Time (default) Access available at any time.
Direct Access [56.4.2]
Use this option to permit access at any time (in conjunction with Access period) to any of
these communication paths or devices: PSTN, GSM, GPRS, Ethernet, USB.
Access is initiated from Remote Servicing. Once access is authorized/initiated, uploading,
downloading and remote servicing can begin.
To Next Page
Loading...
Need help?
General
