Galaxy Flex Installer Manual Codes [42, Quick Menu 7]
67
2. For access control cards, when the serial number is not printed on the card, the card
number can be learned using the Add Batch [42.2.1] option.
MAX Function [42.1.User code.7]
The card/fob/tag/button can be assigned a single menu option. The user must be authorized
to access the menu option assigned to the MAX, either by the user level assigned or the
Menu Access [68] option. The default option is NOT USED.
To assign a new option:
1. Do one of the following:
Press A or B until the required option is displayed.
Enter the option number directly.
2. Press ent to accept the selection.
MAX Keypad [42.1.User code.8]
The menu option assigned to the MAX card can be limited to operate on a single keypad.
When you select this option,
is displayed indicating that a keypad has not been
specified.
To specify a keypad:
1. Press #. The address of the first keypad on the system is displayed.
2. Use A or B to select the required keypad.
3. Press ent to accept the selection.
Note: The address of the keypad that is currently being used is indicated by a black square
flashing over the first digit of the keypad address.
‘Card-Held’ Operation
The programmed MAX function is activated when the card/fob /tag is held continuously in
front of the MAX/MicroMAX/KeyProx reader for 3 seconds.
If using a MAX/MicroMAX or KeyProx the reader or KeyProx must be assigned a common
group to the user. The keypad specified in option 7=MAX function displays the assigned
MAX function.
Assigning Dual Functions to MAX Numbers
If a card has a # assigned to the number, then any card-held function will only work in
c
onjunction with the user’s PIN, provided that the PIN has a # assigned also.
The Dual Focus function will work in either order, but if the card is presented first, the user
has PIN controlled access to the normal menu (see Codes [42] for programming).
If a user’s card number is assigned a
,
then the card becomes Dual access. This means that
it will not open the door without another PIN or card (see Codes [42] for programming).
To Next Page
Loading...
Need help?
General
