Honeywell H2W2PRV3 User Manual

Performance Series IP Camera Software Configuration Guide
34
ONVIF
ONVIF (Open Network Video Interface Forum) is a global open standard for the interface of IP-based
security products. It covers network video mode, interface, data type, and data interaction mode. The
ONVIF specification aims at interoperability of network video products regardless of manufacturer.
The ONVIF setting is enabled by default.
• To enable ONVIF, on the ONVIF tab, click Enable.
• To disable ONVIF, on the ONVIF tab, click Disable.
PPPoE
Figure 5-12 PPPoE Configuration Interface
1. To enable PPPoE, select the Enable checkbox and enter the PPPoE user name and password that
you received from your Internet service provider (ISP).
2. Click Save to save the current setup, and then reboot the camera to activate this new setup. The
camera connects to the Internet via PPPoE after rebooting.
You can access the web client through the DDNS domain name (see DDNS on page 35). To access the
camera using the HonView Touch app, P2P must be enabled (see P2P on page 32).
Note When PPPoE is enabled, disable UPnP so that it does not interfere with PPPoE.

Honeywell H2W2PRV3 Specifications

General

Brand	Honeywell
Model	H2W2PRV3
Category	IP Camera
Language	English