Honeywell H2W2PRV3 User Manual

Performance Series IP Camera Software Configuration Guide
38
Parameter Function
Interval The interval for sending ranges from 0 to 3600 seconds. 0 seconds
means that there is no interval.
The system will not immediately send the email when the alarm occurs.
When an alarm, motion detection, or other event occurs to activate an
email, the system sends the email according to the interval that you have
specified here. This reduces the load on the email server when multiple
emails are triggered simultaneously.
Health Mail Enable Select the check box to enable this function.
Update Period (interval) This allows the system to send a test email to check the connection.
Select the check box to enable this function, and then set the
corresponding email interval.
You can set the Update Period so that the system sends out regularly
scheduled emails.
Email Test The system will automatically send an email to test the connection.
Before you can do an email test, you must save the email setup
information.
UPnP
UPnP lets you establish the mapping relationship between the LAN and the public network. In the UPnP
configuration interface, you can add, modify, or remove a UPnP item.
Figure 5-17 UPnP Configuration Interface
Enabling UPnP in Windows
When UPnP is enabled in Windows, the camera can be detected automatically through My Network
Places.
Note
The UPnP is enabled by default on Windows 7 systems. This procedure
applies to Windows XP.
1. Go to StartControl PanelAdd or remove programs.
2. Click Add or remove programs, and then select Network Services from the Windows Components
Wizard.

Honeywell H2W2PRV3 Specifications

General

Brand	Honeywell
Model	H2W2PRV3
Category	IP Camera
Language	English