Honeywell Lyric - Deleting Wireless Zones or Keys; Updating Six Series Sensor and Key Fob Firmware

Lyric Controller Programming Guide
Program Keys (Continued)
Programming Field
Function and Action
Button Key * - Zn *
* The Key number and
Zn number are
dependent upon the
Key Type selected.
Assign a function to a specific Button Key. The system scrolls through the available
options.
Options:
Disarm
Arm Away
* Options are the same for each
Button/Zone combination.
Arm Stay
No Response
24 Hour Silent
24 Hour Audible
24 Hour Auxiliary
Silent Burglary
Fire No Verification
After all Key Fobs have been enrolled, the SiX™ Series Device firmware should be updated to ensure
the latest version is being used. Refer to the Updating SiX™ Series Sensor and Key Fob firmware
section.
Deleting Wireless Zones or Keys
The following procedure should be used to delete SiX™ Series or 5800 Sensors or Wireless Keys.
Programming Field
Function and Action
Zones
OR
Keys
NOTE:
SiX™ Series sensors must be deleted from the controller before the device can be
enrolled in another system.
1. Enter Zone Programming OR Keys Programming mode.
2. Select the Zone OR Key to be deleted and then select “DELETE”
3. Select “Yes” to confirm the deletion. All programming information for the deleted
device is removed from the system. The system returns to the Zone Programming
screen.
4. Select the “” key to exit the current screen. The system returns to the previous
screen.
Updating SiX™ Series Sensor and Key Fob Firmware
After entering Master User Programming Mode select the “Advanced” icon. Follow the steps below to update
the SiX™ Series Sensor or Key Fob firmware.
Programming Field
Function and Action
Update Sensor
Firmware
OR
Update Keyfob
Firmware
1. Select “Start” to initiate Firmware Update and follow the instructions on the Lyric,
as applicable.
2. Select “Stop” when Firmware Update.
3. When the update is completed select the “” key to exit the current screen. The
system returns to the previous screen.
- 17 -