Honeywell Lyric - Program Reporter

Lyric Controller Programming Guide
Program Reporter
Programming Field
Function and Action
Programmed
Default
Report Selection
Enable or disable Reporting of Specific Events. Use the down “
˅”
arrow to scroll to the next page of options. Use the “
˄
” arrow to
return to the previous page.
Not Applicable
Arm Away
Enable or disable reports to the Central Station when the system
is Armed Away.
The system toggles between “Disabled” and “Enabled”.
Enabled
Arm Stay
Enable or disable reports to the Central Station when the system
is Armed Stay.
The system toggles between “Disabled” and “Enabled”.
Enabled
Disarm
Enable or disable reports to the Central Station when the system
is Disarmed.
The system toggles between “Disabled” and “Enabled”.
Enabled
Exit Error
Enable or disable reports to the Central Station when an Exit Error
is detected.
This field is always “Enabled” and is not selectable.
Enabled
Recent Closing
Enable or disable reports to the Central Station when the system
is Armed Away and any burglary zone is faulted (within two
minutes after the initial exit delay expires).
This field is always “Enabled” and is not selectable.
Enabled
Event Log Full
Enable or disable reports to the Central Station when system
detects that the Event Log is full.
The system toggles between “Disabled” and “Enabled”.
Enabled
Trouble
Enable or disable reports to the Central Station when the system
detects that a Zone has a Trouble condition.
The system toggles between “Disabled” and “Enabled”.
Enabled
Trouble Restore
Enable or disable reports to the Central Station when the system
detects that a zone that had been in Trouble has been restored.
The system toggles between “Disabled” and “Enabled”.
Enabled
Alarm Restore
Enable or disable reports to the Central Station when the system
detects that a zone that had been in Alarm has been restored.
The system toggles between “Disabled” and “Enabled”.
Enabled
Alarm Cancel
Enable or disable reports to the Central Station when Alarm has
been cancelled
The system toggles between “Disabled” and “Enabled”.
Enabled
Test
Enable or disable reports to the Central Station when a Test has
been initiated.
This field is always “Enabled” and is not selectable.
Enabled
Test Restore
Enable or disable reports to the Central Station when a Test has
been completed.
This field is always “Enabled” and is not selectable.
Enabled
Bypass
Enable or disable reports to the Central Station when a Zone has
been manually bypassed.
The system toggles between “Disabled” and “Enabled”.
Enabled
Bypass Restore
Enable or disable reports to the Central Station when a bypassed
zone has been restored.
The system toggles between “Disabled” and “Enabled”.
Enabled
AC Loss
Enable or disable reports to the Central Station when the system
detects the loss of AC power. This report will be randomized up to
4 hours.
The system toggles between “Disabled” and “Enabled”.
Enabled
AC Loss Restore
Enable or disable reports to the Central Station when the system
detects that AC power has been restored.
NOTE:
This report will be randomized up to 4 hours.
The system toggles between “Disabled” and “Enabled”.
Enabled
- 18 -