Honeywell MagneW 3000 Plus - Terminal Connections Diagram

1/98 MagneW 3000 PLUS Specification and Application Guide 9
Terminal Connections
Figure 8 shows typical wiring connections for both the integral and remote types.
—1-contact input and 1-contact output
—2-contact inputs
—2-contact outputs
23447
Flow rate
signal input
Current output
Pulse output
Excitation output
Contact input,
input 1, or output 2
Contact output,
input 2, or output 1
Power supply
AC or DC 24V
Not used
Class 3 grounding
I.OUTP.OUT
E
+–+–
SB SA C A
B
+–+–
XY
LN
POWER
**
*
STATUS IN
STATUS IN1
STATUS OUT2
STATUS OUT
STATUS IN2
STATUS OUT1
OR
OR
+–+–
LN
Flow rate
signal input
+–+–
NOTE: FOR INTEGRAL CONVERTER/DETECTOR:
Terminal symbols X, Y, SB, SA, A, B, C, and E are not indicated
because these terminals are not used.
SIG EX
ABCXY
WARNING
Not used
XY
Not used
B
E SB SA C A
REMOTE CONVERTER
TERMINAL CONNECTOR BOX
REMOTE
DETECTOR
TERMINALS
Figure 8—Typical Wiring Connections for the MagneW 3000 PLUS Remote and Integral Flowmeters