Honeywell MagneW 3000 Plus - Magnew 3000 PLUS Submersible Remote Detector Flange Type; Size 25-600 Mm

36-KI-16-34
Issue 3
Page 1 of 4
MagneW 3000 PLUS Submersible
Model Selection Guide
Remote Detector, Flange Type,
Size 25-600mm (with Integral Cable)
Instructions
Select the desired key number. The arrow to the right marks the selection available.
Make one selection from Tables I thru III, using the column below the proper arrow.
Select as many Table IV options as desired. (If no selections are desired, specify 00.)
A dot ( ) denotes unrestricted availability. A letter denotes restricted availability.
Restrictions follow Table IV.
A complete Model Number must have the designated number of digits in each table.
Key Number I II III IV V
_ _ _ _ _ _ - _ _ _ _ _ _ _ _ _ _ _ _ _ - _ - _ - _ , _ - _ _ _ _ _ _
VI VII
- _ - _ _ _ _ _
KEY NUMBER Selection Availability
Description
MagneW 3000
PLUS Submersible Remote Detector, Flange Type,
MGG19F
Sizes 25-600mm
TABLE I
A - Diameter Flow Range Minimum Flow Range Maximum
Millimeter Inches
In US GPM In Litres In US GPM In Litres
25 1.0 0.779 2.95 77.931
295.00 025 _ _ _ _ _ _ _ _ _ _
40 1.5 1.990 7.53 199.011 753.34 040 _ _ _ _ _ _ _ _ _ _
50 2.0 3.113 11.78 311.285 1178.34 050 _ _ _ _ _ _ _ _ _ _
65 2.5 5.239 19.83 523.945 1983.34 065 _ _ _ _ _ _ _ _ _ _
80 3.0 7.969 30.17 796.924 3016.68 080 _ _ _ _ _ _ _ _ _ _
100 4.0 12.46 47.17 1246.02 4716.68 100 _ _ _ _ _ _ _ _ _ _
125 5.0 19.46 73.67 1946.08 7366.69 125 _ _ _ _ _ _ _ _ _ _
150 6.0 28.00 106.00 2800.24 10600.04 150 _ _ _ _ _ _ _ _ _ _
200 8.0 49.80 188.50 4979.68 18850.07 200 _ _ _ _ _ _ _ _ _ _
250 9.8 77.80 294.50 7779.92 29450.11 250 _ _ _ _ _ _ _ _ _ _
300 11.8 112.05 424.17 11205.37 42416.82 300 _ _ _ _ _ _ _ _ _ _
350 13.8 152.52 577.34 15251.64 57733.55 350 _ _ _ _ _ _ _ _ _ _
400 15.8 199.19 754.00 19918.71 75400.28 400 _ _ _ _ _ _ _ _ _ _
450 17.7 252.11 954.34 25210.99 95433.69 450 _ _ _ _ _ _ _ _ _ _
500 19.7 311.28 1178.34 31128.49 117833.77500 _ _ _ _ _ _ _ _ _ _
600 23.6 448.17 1696.51 44817.09 169650.63
600 _ _ _ _ _ _ _ _ _ _
B - Liner
PFA _ _ _ P _ _ _ _ _ _ _ _ _
Polyurethane Rubber (25 to 200mm only)
_ _ _ Q _ _ _ _ _ _ _ _ _
d
C - Pipe Connection Flange Material
Flange JIS10K Standard _ _ _ _ J11 _ _ _ _ _ _
Flange JIS20K Standard _ _ _ _ J21 _ _ _ _ _ _
Flange JIS30K (diameter 25mm-200mm only) Standard _ _ _ _ J31 _ _ _ _ _ _
f
Flange ANSI 150 Standard _ _ _ _ A11 _ _ _ _ _ _
Flange ANSI 300 (diameter 25mm-450mm only) Standard _ _ _ _ A21 _ _ _ _ _ _
m
Flange JIS G3451 F12 (diameter 80mm or larger) Standard _ _ _ _ G11 _ _ _ _ _ _ h
Flange DIN PN10 Standard _ _ _ _ D11 _ _ _ _ _ _
Flange DIN PN16 Standard _ _ _ _ D21 _ _ _ _ _ _
Flange DIN PN25 Standard _ _ _ _ D31 _ _ _ _ _ _
Flange DIN PN40 (diameter 25mm-200mm only) Standard
_ _ _ _ D41 _ _ _ _ _ _
f
Table I continued on next page.