Cable Installation (Interface Specific)
RS232
11. Configure the MS2420 scanner to match the host system’s RS232 parameters.
Note: Refer to the MetroSelect Configuration Guide (PN 00-02407x) under Section G: RS232 for
enabling RS232 Mode (scan the recall defaults bar code first).
Refer to the MS2xxx Stratos Series Configuration Addendum (PN 00-02034x) for scale, dual
cable and single cable configuration bar codes.
xx** Specifies international connection. See the Base Kit Components
and Optional Accessories section of this guide for a complete listing.
See Power Source caution statement located on page 12 of this
manual.
Figure 16. RS232 Interface Cable Installation Schematic
19
To Next Page
Loading...
