FCC Part 15 Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Operation Area and Conditions
Hazardous Areas classified by Zones
PGM62x0/PGM62x6are intended to be used in hazardous areas zone 0, zone 1 or zone 2,and
PGM62x8 in hazardous areas zone 1 or zone 2 within the temperature range of -20º C to +50º
C, where gases of explosion groups IIA, IIB or IIC and T4 may be present.
Hazardous Areas classified by Divisions
PGM62x0/PGM62x6/PGM62x8are intended to be used in hazardous areas classified for Class
I &II Div. 1 or 2, within the temperature range of -20º C to +50º C, where gases of explosion
groups A, B, C, D, T4; Groups E, F, G; T85°C.
WARNINGS:
1. NDIR sensors shall not be installed in PGM62x0 or PGM 62x6 models.
2. NDIR LEL sensors shall not be installed in PGM62x8 diffusion models bearing cCSAus logo.
Proper Product Disposal at End of Life
The EU Directive 2012/19/EU: Waste Electrical and Electronic Equipment (WEEE)
This symbol indicates that the product must not be disposed of as general industrial or
domestic waste. This product should be disposed of through suitable WEEE disposal facilities.
For more information about disposal of this product, contact your local authority, distributor, or
the manufacturer.
Recommended Storage Conditions
Storage Temperature: 0° C to 20° C (32° F to 68° F)
Storage Humidity:15% to 90% RH (relative humidity), non-condensing; preferred 30% to
70% RH
0% RH preferred sealed storage for PID and NDIR sensors
Storage Pressure: 90 to 110kPa
Storage Life: 6 months in sealed container (no air)
Honeywell MultiRAE Series™ 5 User Manual
To Next Page
Loading...
Need help?
General
