Honeywell MultiRAE Series - Datalogging Process Options: Manual and Snapshot

Datalog Type
The instrument offers three options for starting the datalogging process:
AutoAutomatically collects datalog information every time the instrument is sampling until
the datalog memory is full.
ManualDatalogging occurs only when you manually initiate it (see below for details).
SnapshotCaptures a single event when you press [MODE].
Note: You can only choose one datalog type to be active at a time.
About Manual Datalogging
When the instrument is set to Manual Datalog, you can turn datalogging on and off by
repeatedly pressing [N/-] and stepping through the screens from the main display until you
reach the screen that says “Start Datalog?”
l
When you reach the screen that says “Start Datalog?” press [Y/+] to start it. You see
“Datalog Started,” confirming that datalogging is now on. You can turn it off by pressing
[Y/+] again.
l
If datalogging is running, you can leave it running. However, if you want to turn it off,
follow this procedure:
Press [N/-] repeatedly to step through the screens until you reach the screen that says, “Stop
Datalog?” Press [Y/+] to stop datalogging. The screen displays “Datalog Stopped” for a few
seconds, before displaying “Start Datalog?” and the datalog interval. You can restart it anytime
by pressing [Y/+] from that screen.
About Snapshot Datalogging
When the instrument is in Snapshot datalogging mode, it captures a single “snapshot” of the
data at the moment of your choosing. All you have to do is press [MODE] each time you want to
capture a snapshot of the data at that instant.
No snapshot.
Press [MODE] for a
snapshot.
Datalog icon is shown momentarily during a
snapshot
Honeywell MultiRAE Series™ 100 User Manual