Honeywell MultiRAE Series User Manual

LCD Contrast
The display’s contrast can be increased or decreased from its default setting. You may not need
to ever change the default setting, but sometimes you can optimize the display to suit extreme
temperature and ambient brightness/darkness conditions.
Use the [Y/+] and [N/-] keys to decrease or increase LCD contrast, respectively (the bar graph
aids in setting it). When you are done, press [MODE] to select “Done.” If you have not made a
change, it exits to the submenu’s next selection. If you have made a change, you are prompted
at the next screen to press [Y/+] to save the change or [N/-] to undo the change and exit to the
next submenu selection.
Operation Mode
There are two operation modes, outlined below.
Hygiene Mode
When the MultiRAE is in Hygiene Mode, it continuously monitors, and if datalogging is on, it
saves data continuously. Refer to page See "Modes of Operation" on page59 for more
information. for more information on operation in Hygiene Mode.
Search Mode
When the instrument is in Search Mode, it only samples when you activate sampling. When you
see the display that says, “Ready…Start sampling?” press [Y/+] to start. The instrument
Honeywell MultiRAE Series™ 109 User Manual

Honeywell MultiRAE Series Specifications

General

Brand	Honeywell
Model	MultiRAE Series
Category	Gas Detectors
Language	English