Pairing A MultiRAE BLE Module in App Mode
To use the MultiRAE equipped with BLE to communicate with a smartphone running Device
Configurator, you must follow the instructions in the App (Device Configurator or Safety
Communicator) for pairing. When you invoke the MultiRAE, the MultiRAE screen will show a
pairing screen similar to this:
Type the pairing code into mobile app to pair the instrument and the smartphone/mobile app.
Pairing MultiRAE BLE Module in Profile Mode
When in Profile Mode, the instrument pairing methodology is “just work,” and settings should
be done from the third-party wireless system.
Broken BLE Connection
Sometimes a BLE connection will break. This can occur if there is too much interference, or if
the smartphone running the monitoring app is turned off or goes out of BLE range. When this
happens, this screen is shown on the MultiRAE:
Check for interference (too many BLE communications nearby, too much distance between the
MultiRAE and the smartphone or third-party devices). You may need to turn off the MultiRAE
and exit the app, and then restart both and re-pair.
Honeywell MultiRAE Series™ 173 User Manual
To Next Page
Loading...
