Hygiene Mode
Note: Dashed line indicates automatic progression.
Search Mode
Notes:
l
If the instrument is not equipped with a VOC sensor (PID), or is not equipped with an
LEL sensor, then screens for those sensors (VOC Gas Status and LEL Gas Status,
respectively) are not shown.
l
If the Peak or Min is cleared, the Average is also cleared. In addition, each cycle through
the main screen after they are cleared will route from “Ready… Start sampling?” directly
to Date and Time if you press [N/-] (see red line in diagram below), until you perform a
new sample. Also, if you start sampling again and stop sampling, clear the Peak, or clear
the Min, it advances to Date and Time, as well.
l
The Site ID increases by 1 numeric value each time.
Honeywell MultiRAE Series™ 28 User Manual
To Next Page
Loading...
Need help?
General
