UPCE0- Advanced Properties
Start > Settings > Control Panel > Data Collection > Data Options
l For a device with a Hand Held Products Imager, UPCE0 and UPCE1 are enabled as the same symbology at the
scanner; therefore the only way for the UPCE1 configuration to be used is if UPCE0 is disabled. When UPCE0 is
disabled, it will be scanned by the scanner, but rejected by DCWedge.
l The UPCE0 and UPCE1 parameters are always set to match each other. Therefore if a change is made to a parameter
to either the EPCE0 or UPCE1 Advanced Properties that same change is automatically made to the Advanced
Properties for the other symbology.
Option Default Value
Transmit Check Character Enabled
Transmit Number System Digit Enabled
Expand Version E Disabled
Addenda - Read 2-digit Disabled
Addenda - Read 5-digit Disabled
Addenda - Required Enabled
Insert Separator Disabled
4-114
To Next Page
Loading...
