Honeywell MX9 - Wwan

WWAN
Start > Settings > Control Panel > WWAN
These panels can be used to set the parameters for the Wireless Wide Area Network (WWAN) on the MX9. The WWAN is a
form of wireless network that utilizes a cellular network instead of the spread spectrum network most used by Wireless Local
Area Networks (WLAN).
Factory Default Settings
Connection tab
Status Not Connected
Connect button Dimmed
Admin Login button Enabled
Network tab
Phone, Username, Password, APN Blank
TCP/IP tab
DHCP Enabled, dimmed
DNS Enabled, dimmed
Addresses Pre-populated, dimmed
Autoconnect tab
Automatically connect - turned On Disabled, dimmed
Automatically reconnect Enabled, dimmed
Admin tab
Admin Factory Default Password LXEWWAN
Enable Radio button Dimmed
PIN (Personal Identification Number) Enabled, Blank
PUK (Personal Unblocking Key) Disabled, Dimmed
4-184