Vibrate Indicator
The MX9 has a vibration motor.
It is user-configurable to vibrate on a good scan, bad scan, or via an API call. The vibrations from this motor are detectable
under the handstrap at the rear of non-handle units or through the trigger handle when a trigger handle is installed.
Three vibration duration settings are provided for both good and bad scan. The settings can be assigned using tab. The default
setting for both good scan and bad scan is Off.
Cold Storage
When the MX9 has been configured as a cold storage or low temperature device, a snowflake icon is located under the touch
screen next to the product name.
The MX9, with its special low temperature battery and condensation controlling heaters is designed specifically for use in
freezers and refrigerator environments including transitioning between the two.
See Also: "Main Battery Technical Specifications"
Heating Elements
Heating elements activate when ambient temperature drops below 0°C (32°F). Honeywell recommends using the stylus only
when performing screen touch functions on the display when the temperature drops below freezing.
There may be some condensation as the MX9 moves in and out of cold storage areas. The condensation on the touch screen
and the scan aperture quickly dissipates.
Although no user interaction is required to enable the heating elements, the automatically controlled heating elements can be
enabled and disabled using the options in the Peripherals control panel.
Cables
Note: Do not connect or disconnect cables in a Hazardous location.
l I/O port to USB host and power pigtail for external power
l I/O port to USB client and power pigtail for external power
l I/O port to RS232 with power
l I/O port to RS232 without power
l I/O port to 4-wire headset connector with quick-disconnect capability.
l Ethernet Category 5 cable, 6ft / 2m. (only the Cradle has an RJ-45 port for the Ethernet CatV cable)
Cable connections are covered in more detail in the MX9 User's Guide.
2-9
To Next Page
Loading...
