Honeywell MX9 - Scan Status LED

Scan Status LED
The integrated scanner, and imager, Scan Status LED is centered below the MX9 keypad, next to the Power button.
l Steady green indicates a good scan
l Steady red indicates a scan is in progress
l Steady yellow/amber indicates parameter changes are being written to the integrated scanner/imager engine
The Scan Status LED illuminates when a Scan button on the MX9 is depressed (scan in progress), or the trigger on the
attached handle is pressed (scan in progress), or when the scanner/imager engine parameters have been changed and the
changes are being saved (writing to scan engine). While the changes are being saved, the scanner/imager is inoperable.
l The MX9 Scan Status LED does not illuminate when the Scan button is pressed on a scanner cabled to the MX9 or
cabled to an MX9 cradle communication port. The Scan LED on the cabled scanner/imager illuminates.
l The MX9 Scan Status LED does not illuminate when the Scan button is pressed on a wireless Bluetooth mobile
scanner paired with the MX9. The Scan LED on the wireless Bluetooth mobile scanner/imager illuminates.
Note: A scanned bar code can be accepted as a good scan or a bad scan by the MX9 bar code decoder (as configured). The
pre-selected audible or tactile indicator is activated.
Note: The result of the host processing (as configured) of the good scan bar code data can indicate either accept or reject. If
rejected, a bad scan indicator is activated if the host process has been configured to indicate audible or tactile accept
or reject.
2-8