Password
Start > Settings > Control Panel > Password
Use this panel to set MX9 user access to control panels and power up password properties.
Important: This password must be entered before performing a Load Factory Defaults.
Contact Technical Assistance if entering a power-on or screen saver password does not allow you to disable this password
protection or perform a Load Factory Defaults.
Factory Default Settings
Password Blank
Enter password at Power On Disabled
Enter password at Remote Desktop Screen Saver Disabled
Enter the password in the Password text box, then press Tab and type the password again to confirm it.
Enable the power-on checkbox and, if desired, the screensaver checkbox.
A changed/saved password is in effect immediately.
4-165
To Next Page
Loading...
