Honeywell MX9 - Initial Setup; Connect Via USB; Cable for USB Activesync Connection

Initial Setup
The initial setup of ActiveSync must be made via a USB or serial connection. When there is a Connect icon on the desktop,
this section can be bypassed.
Partnerships can only be created using direct serial or a USB cable connection.
After the partnerships are established, ActiveSync communication can be initiated using:
l USB
l Serial
l Wireless
Connect via USB
The default connection type is USB Client
To change the connection type or to verify it is set to USB, select
Start > Settings > Control Panel > PC Connection
USB Client
This will set up the mobile device to use the USB port. Tap OK and ensure the check box for “Allow connection with desktop
computer when device is attached” is checked.
Tap OK to return to the Control Panel. If desired, any control panel windows may be closed.
IMPORTANT – DO NOT PUT THE MOBILE DEVICE INTO SUSPEND WHILE CONNECTED VIA USB. The device will be
unable to connect to the host PC when it resumes operation.
Connect the correct cable to the PC (the host) and the mobile device (the client) as detailed below. USB will start automatically
when the USB cable is connected, not requiring you to select “Connect” from the start menu.
Cable for USB ActiveSync Connection:
MX9051CABLE - MX9 USB Client Cable Assembly (ActiveSync connection)
l Connect the I/O connector to the I/O port on the bottom of the MX9
l The USB client type A plug on the MX9 cable connects to a USB port on a PC or laptop.
l It is not necessary to connect the power receptacle to the MX9 power adapter in order to use ActiveSync. Do not allow
the device to enter Suspend while connected.
1. USB client type A plug
2. Power receptacle
3. I/O connector
5-2