Honeywell NetAXS NX4S1 - Fiber Converter to RS-485 Connection via NetAXS

NetAXS™ NX4S1 Installation
System Configuration
NetAXS Access Control Unit NX4S1 Installation Guide, Document 800-00008, Revision A 29
Figure 19: RS-485 Connection via PCI-2 with Multidrop Panels at Both Ends
COM Port
It is recommended to Earth Ground (EG) each NetAXS enclosure individually
4
485
ote
EG
EG
one side of cable
RS-485 (4,000 Ft.)
RS-232 (50 Ft. Max.)
EG
EG
EG
n y ar roun
one side of cable
NetAXS
Panel
EG
DIP Switch Settings
S1-S5 Panel Address
S6: OFF
J36 OPEN
J37 OPEN
Terminal