Honeywell NetAXS NX4S1 - Table 5 LED Status

NetAXS™ NX4S1 Installation
NetAXS™ Startup
NetAXS Access Control Unit NX4S1 Installation Guide, Document 800-00008, Revision A 43
The following table indicates the status associated with each LED.
Note: The Ethernet/COM status LED will be green even if no cable is attached.
Table 5 LED Status
LED PWR RUN H485 H232 DS COM LINK RLY RDR
GREEN Power
OK
Blink =
normal
Steady =
malfunc-
tion
Multi-
drop
Receive
Data
RS232
Receive
Data
Down-
stream
Receive
Data
100Mbit Link
OK
Relay
Active
Flash at
read
RED N/A N/A Trans-m
it Data
Trans-m
it Data
Trans-m
it Data
N/A N/A N/A N/A
AMBER N/A N/A TX &
RX
Data
TX &
RX
Data
TX &
RX
Data
N/A TX &
RX
Data
N/A N/A
OFF Power
Off
Mal-
function
No
Com
No
Com
No
Com
10Mbit No
Link
Relay
Off
Normal