Honeywell NOTIFIER AM-8200 - Condition with Fault Zone Events

PAGE - 10 Programming Manual AM_8200
NOTIFIER ITALIA Doc. M-162.1-AM8200-ENG Rev A2 AM8200_manu-prog-ENG
 Condition with Fault zone events
The following display appears when the control panel is in condition of zone faults.
Fault events are also initially displayed for zone
Through arrow keys  you can scroll the list of the Zone Faults.
Through a first pressure of the enter key
you can display the list of devices with the indication of the point
name; refer to the following figure:
Pressing the escape key or leaving the keypad inactive for 30 seconds. you return to the list of faulty areas
Counter
for Faulty zones
Zone with Fault events
Text programmed
for this zone
Detail of the Device in
Fault Condition
Text programmed
for the device
Fault Type description
Counter
of Faulty zones