Honeywell NOTIFIER AM-8200 - Modify; Modify Status - Detectors; Modify Status - Modules

PAGE - 58 Programming Manual AM_8200
NOTIFIER ITALIA Doc. M-162.1-AM8200-ENG Rev A2 AM8200_manu-prog-ENG
When a module is Disabled the control unit is
inhibited to the reception of the Alarm and
Faults signaling from the module.
To Disable a module select it through the
function keys. Once the device has been
selected press the enter key and through
the arrow keys select YES and
subsequently press the enter key to
confirm the disablement.
M
M
O
O
D
D
I
I
F
F
Y
Y
By selecting the “Modify” item, and typing the correct password Level 2, the following display will appear,
where it is possible to change the state of Enabled/Disabled for the various devices
 Modify Status - Detectors
The display shows by default the first device of the first line. To select another device use the function keys.
 Modify Status - Modules
The display shows by default the first device of the first line. To select another device use the function keys.
When a detector is Disabled the control unit
is inhibited to the reception of the Alarm and
Faults signaling from the sensor.
To Disable a detector select it through the
function keys. Once the device has been
selected press the enter key and through
the arrow keys select YES and
subsequently press the enter key to
confirm the disablement.