Honeywell NOTIFIER AM-8200 - Programming - Configuration Menu; CPU and Loops

PAGE - 44 Programming Manual AM_8200
NOTIFIER ITALIA Doc. M-162.1-AM8200-ENG Rev A2 AM8200_manu-prog-ENG
Programming - CONFIGURATION menu
This function allows the configuration of the panel units connected to the Can-Bus Network.


C
C
P
P
U
U
a
a
n
n
d
d
L
L
o
o
o
o
p
p
s
s


C
C
a
a
n
n
B
B
u
u
s
s
R
R
P
P
T
T
Programming the presence on the CAN-BUS network of the AM2-BST-C card (amplifier for CAN-BUS line).
N.B .: Up to 8 AM2-BST-C cards can be installed on the CAN-BUS network
 PRN (Printer Interface Presence Programming)
This function allows you to configure the presence of the interface for connecting a serial printer to
RS232 port
To modify the programmings,
press the enter key ;
use the arrow keys 
to change the parameter;
at the end press the enter key
to confirm.
Press key – CPU or + CPU
to
p
ro
g
ram the
p
revious/next AM-8200 BOX
To modify the programmings,
press the enter key
;
use the arrow keys 
to change the parameter;
at the end press the enter key
to
confirm.