PAGE - 14 Programming Manual AM_8200
NOTIFIER ITALIA Doc. M-162.1-AM8200-ENG Rev A2 AM8200_manu-prog-ENG
Programming – System - System TYPE
This function allows the choice of system Network type as follows:
STANDALONE = Single Panel without Network connection with up to 8 lines
NET 16 = Network of Panels with up to 16 lines in total
NET 128 = Network of Panels with up to 128 lines in total
Programming – System - System Address
The "Address" entry will assign the panel device number on the CAN-BUS network.
Programming – System – LINE
Style: OPEN LINE, CLOSED LOOP
This function allows to change (in memory) the type of line connection,
Through a first pressure of the enter key the Line editing function is activated,
Press one of these key to select the Previous or Next line
To Next Page
Loading...
