Honeywell Notifier RP-2001 - 8: History; View Events

70 RP-2001 Series Manual — P/N 52985:D5 1/26/2017
Programming Master Programming Level
The N-ANN-RLY module provides ten Form-C relays which can be programmed for various
functions. The initial screen displays Relays 1 through 3. Pressing the down arrow key will display
the remaining relays for this module.
To program any of the N-ANN-RLY relays, while viewing the appropriate ANN-RLY Option
screen, press the number key corresponding to the relay to be programmed. Following is a list of
the available programming options for each relay:
• General Alarm
• General Trouble
• General Supervisory
• Future Use
• Future Use
• Future Use
• General Discharge
• Discharge Release 1
• Discharge Release 2
•AC Loss
• Waterflow Delay
• Future Use
• Future Use
• Future Use
• General 2nd Shot Release
• 2nd Shot Release 1
• 2nd Shot Release 2
• Input Zone 1
• Input Zone 2
• Input Zone 3
• Input Zone 4
• Input Zone 5
• Input Zone 6
3.5.8 History
The History option allows an authorized user to view or erase events which have occurred in the
control panel. Pressing 2 while viewing Programming Screen #3 will display the History options as
shown in the following display:
View Events
Pressing 1 while viewing the History Screen will allow the user to select the events to be viewed as
illustrated in the following:
PROGRAMMING
1=ANN-BUS
2=HISTORY
3=WALKTEST
Programming Screen #3
HISTORY
1=VIEW EVENTS
2=ERASE HISTORY
History Screen
HISTORY
1=VIEW ALL
2=VIEW ALARMS
3=VIEW OTHER EVENTS
View Events Screen