Pallet Accuglide ZoneFlex Accumulation Conveyor | Maintenance Manual | 29334206 23
February 14, 2018
Ensure the axles are properly installed into the frame’s
axle holes or pop-out clips.
Listen for unusual noises or vibrations in the bearings.
Observe for buildup of dirt and debris.
Check for oil leakage on the floor or drip pan. Note: If
lubricant leakage persists, repair or replace the gear
reducer.
Monitor the gear reducer for unusual noise, operating
temperature and vibration.
Check the conveyor’s physical condition, looking for
loose fasteners, damaged or wearing components, and
build-up of dirt and/or product spillage.
Listen for unusual noises coming from bearings, motors,
reducers, loose components.
Verify product travels along the length of the conveyor
without obstruction or hesitation.
Inspect driver pad to assure it is properly seated on the
chain and it is not damaged. Remove any build-up of dirt,
oil or any other foreign substance.
Check that safety guards, warning signs, lights, and
alarms are in place and in proper working condition.
Check that all emergency-stop pull cords and/or push
buttons are functioning properly.
Check equipment safety guards, warning signs, lights,
and alarms associated with the operation of the conveyor
system and keep them in good condition to ensure the
safety of all plant personnel.
Any unusual conveyor noises, oil leaks and operational
problems should be reported and promptly corrected.
Check the control devices for cleanliness and proper
operation.
To Next Page
Loading...
