Revision 4.0 STT850 Series HART/DE Option User’s Manual Page 15
5. Process the three warning pop-ups as appropriate, and then select OK in the Put loop in
Manual… pop-up. The QUICK MONITOR box will be displayed. Typical Quick Monitor
dialog is shown below (note that Type will be shown as STT850 etc. based on the Device
Model and parameters will be shown accordingly)
6. Select Upload. A progress bar will be displayed on the QUICK MONITOR box, and when
the upload is complete, the DE MAIN MENU will be displayed. Typical DE Main Menu
dialog is shown below (note that based on the Device Model, ST 800, STT850 etc. the
corresponding Menus will be displayed)
A confirmation request message will be displayed if you select <Back for a Transmitter
that was previously set to Output Mode during calibration, and was not subsequently
cleared. If you confirm the message (Yes answer), the display will exit the DE MAIN MENU.
To Next Page
Loading...
