Honeywell STT850 Series - General Configuration Parameters; Table 5 - General Configuration Parameters

Revision 4.0 STT850 Series HART/DE Option User’s Manual Page 17
4.3.3 General Configuration Parameters
Select the General Button on the DEVICE MAIN MENU page, and configure parameters
according to
Table 5.
Table 5 – General Configuration Parameters
Parameter
Read (R) or
Read/Write (R/W)
Configuration Details
PV Type
R/W
Dual Range Smart Transmitter Digital Communications
(STDC) or Single Range or Single Range with
secondary variable (SV).
Communication
Mode
R/W
Analog, DE 4-byte, or DE 6-byte
FS Direction
R
Failsafe (FS) direction: upscale or downscale, switch
non-selectable on the electronics module. See the
STT850 SmartLine Temperature Transmitter User
Manual for details.
Line Filter
R
Non-selectable: 50hz or 60hz.
T/C Fault
Detect
R/W
Select: Enabled or Disabled.
Select the Back button to go back to the DE MAIN MENU.