22
Mounting Honeywell Versatilis Signal Scout
Honeywell Versatilis™ Signal Scout™ and Honeywell Versatilis™ Signal
Scout™ - Energy Harvested offers multiple mounting options such as
Magnetic Mount, Screw Mount, Adhesive Mount, and Adhesive
Mount (Epoxy compatible)to suit the mounting surface of the target
structure, and to ensure good bonding and accurate measurement
for the HVSS / HVSS - EH.
NOTE: User needs to select the suitable mounting adapter while
placing an order by referring Model Selection Guide (MSG).
The following table includes the list of recommended tools that are
required for installation/ replacement scenarios:
Table 5-2: Recommended Tools
Tool Size
Spanner (for firmly holding the base of
HVSS while tightening the mounting
adapter to it).
41mm
Spanner (for tightening the mounting
adapter to the base of the HVSS)
32mm
Allen Key and Spanner (for firmly holding
the M6 socket head cap screw while
tightening with M6 nut respectively)
Allen key size: 5mm;
and its respective
spanner size: 10mm
Pre-installation Considerations
A. Follow the below procedure when planning to install the HVSS for
the first time in an identified location or when you are planning to
move the installed HVSS from an existing location to a new
different location.
NOTE: This procedure is not applicable while replacing the
HVSS in the same location.
Chapter 5 - Setting up the Honeywell Versatilis Signal Scout
To Next Page
Loading...
