Honeywell Versatilis Signal Scout - Resetting HVSS Passcode

34
For Windows
Platform
For Android Platform For iOS Platform
2. Tap Get.
3. After successful
installation, tap
Open.
installation, tap Open.
4. A permissions dialog
to access the device's
camera appears, tap
While using the app.
4. A message
stating
Honeywell
Versatilis
Connect
would like to
access the
camera
appears, tap
OK.
When the user launches the Honeywell Versatilis
TM
Connect app for
the first time, the app gives a tour of its overall features.
Configuring Honeywell Versatilis Connect App
For more information on how to configure sensor parameters in
HVSS using Honeywell Versatilis
TM
Connect app, see the "Device
Configuration" section in Honeywell Versatilis
TM
Connect App User's
Guide.
Resetting Passcode for HVSS Using Honeywell
Versatilis Connect app
In case you forgot your current passcode (that is different than the
default passcode) required to login to the Honeywell Versatilis
TM
Connect App. You still have an option to reset your current passcode
to the default passcode, using the reed switch provided on the HVSS
/ HVSS - EH, and thereby able to login to the Honeywell Versatilis
TM
Connect App, once again.
Perform the below instructions to reset your current passcode to the
default passcode:
1. Bring the magnet closer to the reed switch location. The LED
blinks red light whenever you bring the magnet closer to the reed
switch.
2. Repeat the above activity (step 1) within a time period of 15
seconds.
Chapter 6 - Configuration